Posted by Vaghn [172.70.211.217] on Saturday, April 26, 2025 at 09:15:51 :
In Reply to: Re: Clutch fork bushings posted by Dan Saucy [172.70.207.67] on Friday, April 25, 2025 at 21:20:22 :
Ok, the C50519 bushing comes solid or split and goes in the right-side of the bellhousing - see link for bushing image. The other two go in the clutch fork flange. All the bushing have to be driven in place. To make installation easier, I apply a little grease in to help the bushings drive in. Harbor Freight has a bushing driver kit that can be used to drive them in. The one that goes into the bellhousing can be a little difficult to line up properly so I use a bolt, washers, and nut with the bushing adaptor to pull it in place. Do use an adaptor to prevent crushing the driven end. Don't worry about them being to tight on the fork, there's plenty of clearance for the fork to move. Some of us install a zerk fitting on the flange to grease it and if your interested see the PIF section, item "K"
Follow Ups: