1952 Power Wagon

This Power Wagon has been mechanically restored to working order.  I can provide videos.  There is very little rust on the body so it is an excellent candidate for full restoration.  It would be ideal for a collector.  It’s odometer reads 51,809.  The original engine is a 230 cubic inch straight 6 flathead.  The VIN is 83925550.  It is stored on a farm north of Newton, Kansas.  

Price: $35,000.

Contact Pete Ferrell 316-259-4773 or email [email protected]

Detailed list of all repairs:

• Installed starter
• Installed new condenser and Plug wires
• Installed new thermostat and gasket
• Installed new water pump, radiator hoses, heater hoses L/F freeze plug.
• Rebuild Carb. Had to order a new kit since one provided was incorrect.
• Installed generator
• Installed new fuel pump
• Installed new fuel line from pump to carb
• Installed new fuel line from pump to tank
• Remove cylinder head and intake/exhaust to grind the valves. Replaced all of the intake valves and had the cylinder head machined.
• Removed and replaced both battery cables
• Bent and installed brakes lines
• Installed new brake hoses
• Installed new wheel cylinders and remanufactured brake shoes
• Installed new master cylinder
• Cleaned, reinstalled hubs on drums and machined
• Replaced worn bearings on right front hub
• Repacked wheel bearings and installed drum/hubs on all four wheels with new seals and gaskets.
• Bleed brake lines
• Dismounted all wheels found 4 of 5 to be rusted beyond safe use.
• Repaired wires, installed new bulbs and installed headlight assemblies
• Drained and replaced fluid in the front axle, rear axle, transmission and transfer case.
• Removed rear driveshaft to replace oil seal on the back of the transfer case.
• Replace rear u-joints
• Replace u-joints on driveshaft between transmission and transfer case
• Had 4 used and one original wheels powder coated
• Installed new tires, tubes and flaps
• Installed new muffler
• Installed new rear tail lights and brackets.
• Installed new stainless steel fuel tank and filler neck.
• Blast and paint windshield frame. Install glass and weather strip
• Blast and paint side windows, install glass, install weather strips
• Removed window regulators to clean and lube
• Install new inside/outside door handles and window crank handles.
• Install new tail pipe and brackets/clamps.
• Change engine oil and filter
• Topped off oil in pto winch. Found to be leaking severely. Will need to be removed and resealed
• Replaced broken speedometer cable.
• Found speedometer to be seized. Removed, freed up and lubricated.
• Installed new rear glass.
• Removed damaged left front door latch – welded on latch to repair, but still should be replaced – not available at this time
• Installed new wiring harness, ignition switch, interior light switch and switch knobs
• Installed new rear-view mirror
• Removed heater to clean, repair and rewire. Reinstalled
• Tested amp gauge and fuel gauge. Both need replaced, but not available at this time.
• Tested generator and voltage regulator. Charges to about 25 amps.
• Made bracket to install horn on engine.
• Installed new inside door handle - drivers side
• Right cowl light needs replaced - back ordered from VPW
• Replaced wiring to spot light and installed fuse - works correctly
• Install customer supplied spark plugs, coil, cap, and points.