Waking up an early 1951 Power Wagon


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Keith in Washington [104.22.118.56] on Tuesday, November 03, 2026 at 14:42:59 :

I am posting this to show the process of finding out why a truck that has been sitting for a few years will not start.

My early 51 PW has been trapped in the garage for 2+ years. The garage is insulated and dry and pest free. This last week I decided to wake it up. I put gas in the tank and down the throat of the carb and tried to start it several times with no joy. I knew gas was there so it must be spark. So I started checking. The wire to the coil is original 1951 and had a few bare spots. I put shrink tube over its length cleaned and reinstalled the connector. I did the same for the wire from the starter to the Amp meter. I checked the coil it was good. The points looked good and were set to .020 and I cleaned the points with emery paper. Cleaned the rotor and check the wire from to coil to the distributor. All was fine. I then put my test light into the coil and it lighted up when I cranked the engine.

Ok back to putting gas down the carb and it kicked and dab for 3 seconds. I did this 3 times with the same result. It apparently was not getting gas from the tank. I checked the glass bowl filter on the fuel pump and there was gas. I unscrewed the plug in the carb fuel bowl and gas came out. I emptied the bowl into a cup. I then poured fuel in the throat of the carb twice and in ran for a few seconds. I then took the plug out of the fuel bowl and it was full of gas. So now I know something was wrong in the carb. I took the carb out and took it apart and the bowl. Was full of scum from gas evaporation. I cleaned everything with carb cleaner and put it back together and poured fuel down the carb and it started and idled and ran perfectly. There was a smile on my face.

The second issue is that I had no headlights, tail lights, brake lights, panel lights or cowls lights. I know that my headlight switch is worn as I rebuilt it several years ago. I have a NOS headlight switch but I don�t have the correct knob for it. I also installed a NOS ignition switch a few years ago. I could not believe that I found them. So when checking the lighting issue I found that if I flexed the wires coming into the circuit breaker at the rear of the switch I could get lights. Looking at the wiring diagram the brake lights come off the circuit breaker. Since the break lights were out that told me that power was not getting through the circuit breaker and that the headlight switch is fine. The wire coming from the ignition switch to the headlight switch is good. Flexing the wires that attach to the circuit breaker actually flexes the posts on the circuit breaker which breaks electrical connection. That tells me that the circuit breaker works intermittently. Problem solved.

The last issue is I have only about 4 1/2 volts at the coil.this seems to be a little low. So somewhere I am getting a voltage drop. I have not figured out where. It not the ignition switch as it is new. I may have a corroded connection that I have not found as yet.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button