Posted by Clint Dixon [172.71.255.70] on Tuesday, October 06, 2026 at 07:08:41 :
In Reply to: Body Mounts posted by CB [162.158.159.166] on Monday, October 05, 2026 at 11:57:53 :
Yes and no.
Wooden blocks and fiber pads were used up to a point in time. I would have to look it up to quote the exact serial number, but it was sometime after the WDX and before the B3PW that they switched to rubber mounts.
The key here is when they switched to rubber mounts, the frame brackets changed location of their vertical placement.
So straight out swap between the two? - No. Willing to do some custom work? - Yes.
No that you are adapting a non Power-Wagon cab onto a Power-Wagon frame, that may throw another monkey wrench, or two, into the works. You are cutting the sill below the doors down to the size that the Power-Wagon used, correct?
As long as you have about a 3/4" to 1" gap between the cab and the running board (assuming the running board mounts and their wooden blocks are in great condition), you should be fine. All the rest from the firewall forward gets shimmed/adjusted to align with the cab.
Junior
Follow Ups: