Posted by Dan in TN [172.69.208.163] on Thursday, June 12, 2025 at 11:46:20 :
In Reply to: Re: Main Bearing Oil Hole Alignment posted by Vaughn [172.69.134.71] on Thursday, June 12, 2025 at 09:50:44 :
I'm not sure I trust my DIY machinist skills enough to file it out on my own, so I'm leaning towards the NOS replacement if I can find one.
Vaughn - do you have any leads on where I could find a .010 oversized bearing (crank was ground while it was out), or what part number I should be looking for with a .010 oversized NOS part? I haven't looked to extensively yet, but the part numbers from the PIF seem to be returning full sets and the NOS individual rear mains on eBay have been a mix of standard, .060 over (I think), or not indicated.
Follow Ups: